Wera 074792-010 Custom Pre-Set Fixed Torque Screwdriver, 0.3 - 1.0 Nm

For any application where the same constant torque and repeat accuracy are required
Factory pre-set torque screwdriver with Rapidaptor quick-release chuck
Desired fixed torque setting can be specified in the following units: Nm, kgf. m, lbf. ft., ozf. in., dN. m, kgf. cm, lbf. in, in. oz, cN. m, gf. m, ft. lb, gf. cm, in. lb.
Fixed value can be easily adjusted between 0.3 and 1.0 Nm using Wera's Recalibration Kit and any appropriate torque tester
Rapidaptor technology for rapid 1/4" hex bit change
Distinct signal when pre-set value is reached
Multi-component Kraftform handle for high working speeds
Unlimited counter-clockwise torque for loosening stuck screws
Handle length: 89 mm
Total length: 133 mm
Manufacturer's part number 05074792010

Note: this screwdriver is pre-set at the factory and requires a specified torque value at the time of ordering.